Cisco ISE Software Configuration Guide - Page 59

Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers How to Configure AToM VCs on the 4-Port ATM ISE Line Card Step 8 Command or Action interface atmslot/port Purpose Specifies an ATM interface or subinterface to configure. Step 9 Example: Router(config)# interface atm1/0 atm clock internal Causes the ATM interface to generate the transmit clock internally. Step 10 Example: Router(config)# atm clock internal atm pvp vpi l2transport Step 11 Example: Router(config-if)# atm pvp 100 l2transport cell-packing cells mcpt-timer timer Specifies a PVP with the specified virtual path identifier (VPI). The l2transport keyword indicates that the PVC is a switched PVC and not a terminated PVC. Enables cell packing and specifies the cell packing parameters. Example: Router(config-atm-l2trans-pvc)# cell-packing 10 mcpt-timer 1 The cells value represents the maximum number of cells to be packed into an MPLS packet. The range is from 2 to 28. The timer value allows you to specify which timer to use. Step 12 vbr-nrt pcr scr mbs Specifies VBR-nrt shaping. Example: Router(config-if-vc)# vbr-nrt 3000 2000 200 The pcr value indicates the peak cell rate, and its range is from 38 to 622000 Kbps. The scr value indicates the sustainable cell rate, and its range is from 38 to pcr Kbps. The mbs value indicates the maximum burst cell size, in number of cells. Step 13 service-policy output policy-map-name Note In place of the vbr-nt command, you can use the cbr, vbr-rt, or ubr commands to configure CBR, VBR-rt, or UBR shaping in the same way. Attaches the queue-limit service policy to the PVC. Step 14 Example: Router(config-pmap-c)# service-policy output out_vbr-nrt xconnect peer-router-id vcid encapsulation mpls Binds the attachment circuit to a pseudowire VC. Example: Router(config-atm-vc)# xconnect 2.2.2.2. 121 encapsulation mpls Example Router> enable Router# configure terminal Router(config)# policy-map out_vbr-nrt Router(config-pmap)# class class-default Router(config-pmap-c)# queue-limit 400 cells Router(config-pmap-c)# exit Cisco IOS Release 12.0(27)S 59