Computer Associates BABNWUP900NE6 Administration Guide - Page 277
Software Requirements
![]() |
UPC - 757943261509
View all Computer Associates BABNWUP900NE6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
Installing and Configuring BrightStor ARCserve Backup on a Cluster for Job Failover Software Requirements ■ For Active/Passive job failover capability, BrightStor ARCserve Backup must be installed on a shared disk of the cluster with the same drive letter assigned to the volume from all nodes. ■ Install the same BrightStor ARCserve Backup components on all nodes. You must configure each of these components in the same way. ■ Use the same BrightStor ARCserve Backup Device Group Name for the same devices in BrightStor ARCserve Backup configuration on each node of the MSCS cluster. To ensure this, use the default Device Group Names assigned by BrightStor ARCserve Backup when you use Device Configuration. ■ The BrightStor ARCserve Backup system accounts must be the same for all BrightStor ARCserve Backup servers installed on each of the cluster nodes. Installing and Configuring BrightStor ARCserve Backup on a Cluster for Job Failover The following sections provide information on installing and configuring BrightStor ARCserve Backup on a cluster. Installing BrightStor ARCserve Backup The following sections provide information about the two ways in which BrightStor ARCserve Backup can be installed on a MSCS node in a cluster. Installing on the Private Disks of Cluster Nodes BrightStor ARCserve Backup job failover is not supported on the private disks of cluster nodes. This configuration does not provide High Availability for BrightStor ARCserve Backup services. This installation is similar to normal BrightStor ARCserve Backup installation. See the BrightStor ARCserve Backup Getting Started for installation information. BrightStor ARCserve Backup Cluster Support A-5
![](/manual_guide/products/associates-arb6002700wf0-administration-guide-d9ef855/277.png)