D-Link DIS-200G Emulator - Page 33

DIS-200G Series Industrial Gigabit Ethernet Smart Managed Switch Time Profile Select the name of the time range to determine the activation period. Click the Delete Time Profile button to clear the setting in the corresponding Time Range field. Click the Apply button to accept the changes made. PD Alive This window is used to configure the PD Alive function for PDs connected to the PoE ports. The ping function is used to check if PDs, connected to the PoE ports, are active or not. When PDs appear to be inactive, the specified action (Reset, Notify, or Both) will be taken. View the following window, click System > PoE > PD Alive, as shown below: Figure 4-10 PD Alive window The fields that can be configured are described below: Parameter From Port / To Port PD Alive State PD IP Address Poll Interval Retry Count Waiting Time Action Description Select the appropriate port range used for the configuration here. Select to enable or disable the PD Alive function on the specified port(s). Enter the IP address of the PD here. Enter the poll interval here. This is the interval between ping messages from the system to PDs connected to the PoE port(s). The range is from 10 to 300 seconds. Enter the retry count here. This is the amount of ping messages that will be sent (at each interval) when PDs are not responding. The range is from 0 to 5. Enter the waiting time here. This is how long the system will wait before sending ping messages to the PD connected to the PoE port after a 'Reset' action was taken. The range is from 30 to 300 seconds. Select the action that will be taken here. Options to choose from are Reset, Notify, and Both. Reset - Specifies to reset the PoE port state (turn PoE off and on). Notify - Specifies to send logs and traps to notify the administrator. Both - Specifies to send logs and traps to notify the administrator and to reset the PoE port state (turn PoE off and on). Click the Apply button to accept the changes made. 26