Dell PowerEdge MX750c EMC Installation and Service Manual - Page 23

Steps, To protect the I/O connector pins, install the I/O connector cover every time a sled is removed

Get Dell PowerEdge MX750c PDF manuals and user guides View all Dell PowerEdge MX750c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

2. Power off the sled. Steps 1. Press the blue release button on the sled to release the sled handle. 2. Holding the sled handle, slide the sled out of the enclosure. NOTE: Support the system with both hands while sliding it out of the enclosure. NOTE: Removing the sled with the enclosure powered on is supported if you shut down the sled before removal. Figure 11. Removing the sled from enclosure 3. Install the I/O connector cover on the sled. CAUTION: To protect the I/O connector pins, install the I/O connector cover every time a sled is removed from the enclosure. Installing and removing system components 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
2.
Power off the sled.
Steps
1.
Press the blue release button on the sled to release the sled handle.
2.
Holding the sled handle, slide the sled out of the enclosure.
NOTE:
Support the system with both hands while sliding it out of the enclosure.
NOTE:
Removing the sled with the enclosure powered on is supported if you shut down the sled before removal.
Figure 11. Removing the sled from enclosure
3.
Install the I/O connector cover on the sled.
CAUTION:
To protect the I/O connector pins, install the I/O connector cover every time a sled is removed
from the enclosure.
Installing and removing system components
23