Dell PowerEdge MX750c EMC Installation and Service Manual - Page 87
Removing the mini Mezzanine card blank, Installing the mini Mezzanine card HBA330 MMZ
![]() |
View all Dell PowerEdge MX750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
NOTE: The mini Mezzanine card is supported only on systems with two processors. Steps 1. Remove the connector cap on the I/O connector of the mini Mezzanine card. 2. Pull the blue pull tag to raise the lever on the mini Mezzanine card. 3. Align the mini Mezzanine card connector with the connector on the system board. 4. Insert the mini Mezzanine card firmly until it is fully seated. Figure 81. Installing the mini Mezzanine card (HBA330 MMZ) 5. Close the lever on the mini Mezzanine card. Next steps 1. Follow the procedure listed in After working inside your system. Removing the mini Mezzanine card blank Prerequisites CAUTION: To ensure proper system cooling, the mini Mezzanine blank must be installed in the mini Mezzanine socket. NOTE: The removal of the blank is recommended only if you intend to install a mini Mezzanine card in the socket. 1. Follow the safety guidelines listed in Safety Instructions. 2. Follow the procedure listed in Before working inside your system. Steps Lift the mini Mezzanine card blank from the slot to remove it from the system. Installing and removing system components 87
![](/manual_guide/products/dell-poweredge-mx750c-emc-installation-service-manual-ea74fc2/87.png)