Dell PowerEdge MX750c EMC Installation and Service Manual - Page 40
Installing drive backplane
![]() |
View all Dell PowerEdge MX750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Figure 31. Installing drive backplane Next steps 1. Connect the incoming power cable to the backplane and then verify both power and signal cable connections are fully seated to the backplane and system board. 2. Connect the integrated cable to the backplane and system board if there is no PERC card installed in the system. 3. Install all the drives. 4. Follow the procedure listed in After working inside the system. 40 Installing and removing system components
![](/manual_guide/products/dell-poweredge-mx750c-emc-installation-service-manual-ea74fc2/40.png)
Figure 31. Installing drive backplane
Next steps
1.
Connect the incoming power cable to the backplane and then verify both power and signal cable connections are fully seated
to the backplane and system board.
2.
Connect the integrated cable to the backplane and system board if there is no PERC card installed in the system.
3.
Install all the drives
.
4.
Follow the procedure listed in
After working inside the system
.
40
Installing and removing system components