Dell PowerEdge MX750c EMC Installation and Service Manual - Page 72
Removing the Jumbo PERC card, Installing the PERC card H755 MX
![]() |
View all Dell PowerEdge MX750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Figure 65. Installing the PERC card (H755 MX) Next steps 1. Connect the cable to the PERC card. 2. Follow the procedure listed in After working inside your system. Removing the Jumbo PERC card Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Disconnect the cable connected to the Jumbo PERC card. Steps 1. Pull the blue pull tag to raise the lever up on the Jumbo PERC card. 2. Holding the blue pull tag, lift the Jumbo PERC card away from the system. 3. Install the connector cap on the I/O connector of the Jumbo PERC card. 72 Installing and removing system components
![](/manual_guide/products/dell-poweredge-mx750c-emc-installation-service-manual-ea74fc2/72.png)
Figure 65. Installing the PERC card (H755 MX)
Next steps
1.
Connect the cable to the PERC card.
2.
Follow the procedure listed in
After working inside your system
.
Removing the Jumbo PERC card
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Disconnect the cable connected to the Jumbo PERC card.
Steps
1.
Pull the blue pull tag to raise the lever up on the Jumbo PERC card.
2.
Holding the blue pull tag, lift the Jumbo PERC card away from the system.
3.
Install the connector cap on the I/O connector of the Jumbo PERC card.
72
Installing and removing system components