Dell PowerEdge MX750c EMC Installation and Service Manual - Page 68

Installing the processor and heat sink PHM

Get Dell PowerEdge MX750c PDF manuals and user guides View all Dell PowerEdge MX750c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 68 highlights

NOTE: Ensure that the processor and heat sink is held parallel to the system board to prevent damaging the components. Figure 60. Installing the processor and heat sink (PHM) 3. Set the Anti-Tilt wires to the locked position (outward position), and then using the Torx #T30 screwdriver, tighten the screws (8 in-lbf) on the heat sink in the order below: a. Tighten the first screw three turns. b. Tighten the screw diagonally opposite to the screw you tighten first. c. Repeat the procedure for the remaining two screws. d. Return to the first screw to tighten it completely. 68 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
NOTE:
Ensure that the processor and heat sink is held parallel to the system board to prevent damaging the
components.
Figure 60. Installing the processor and heat sink (PHM)
3.
Set the Anti-Tilt wires to the locked position (outward position), and then using the Torx #T30 screwdriver, tighten the
screws (8 in-lbf) on the heat sink in the order below:
a.
Tighten the first screw three turns.
b.
Tighten the screw diagonally opposite to the screw you tighten first.
c.
Repeat the procedure for the remaining two screws.
d.
Return to the first screw to tighten it completely.
68
Installing and removing system components