Dell PowerEdge MX750c EMC Installation and Service Manual - Page 39

Installing drive backplane

Get Dell PowerEdge MX750c PDF manuals and user guides View all Dell PowerEdge MX750c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

Figure 30. Removing drive backplane Next steps 1. Replace the drive backplane. Installing drive backplane Prerequisites 1. Follow the safety guidelines listed in Safety instructions 2. Follow the procedure listed in Before working inside the system. 3. Remove all the drives. Steps 1. Verify backplane connector pins are not bent and then connect the signal cable to the backplane. 2. Align the guide pins on the backplane with the guides on the sled. 3. Insert the backplane into the guides and lower the backplane firmly until it is fully seated. NOTE: To install the backplane, ensure the two pins on the backplane tab seat into the two slots on the system chassis. Installing and removing system components 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
Figure 30. Removing drive backplane
Next steps
1.
Replace the drive backplane
.
Installing drive backplane
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
2.
Follow the procedure listed in
Before working inside the system
.
3.
Remove all the drives.
Steps
1.
Verify backplane connector pins are not bent and then connect the signal cable to the backplane.
2.
Align the guide pins on the backplane with the guides on the sled.
3.
Insert the backplane into the guides and lower the backplane firmly until it is fully seated.
NOTE:
To install the backplane, ensure the two pins on the backplane tab seat into the two slots on the system chassis.
Installing and removing system components
39