Epson 1715C User's Guide - Page 26

note You can set the projector to automatically turn off the projector lamp and enter "sleep mode" when it has not received any signals for 30 minutes. This conserves electricity, cools the projector, and extends the life of the lamp. If you want to start projecting again, press the P Power button. If you are done using the projector, unplug the power cord. To enable sleep mode, see page 127. You see a confirmation message. (If you don't want to turn it off, press any other button.) 3. Press the PPower button again. The lamp turns off. When the projector beeps twice, you can unplug the power cord. (If the projector is mounted on the ceiling, you will need to wait 20 seconds for the projector to cool down before you can unplug the power cord.) If you want to turn the projector on again, make sure the orange light is not flashing, then press the PPower button. 4. If you extended the adjustable front foot, press up on the blue foot release lever to retract it. 5. Close the A/V Mute slide. Using the Direct Power On Function The Direct Power On function enables faster setup. The projector will start up automatically when you plug it in; you won't have to press the PPower button. Follow these steps to enable Direct Power On: 1. Press the Menu button on the remote control and select the Extended menu. 2. Choose Operation and press Enter. 3. Choose Direct Power On and press Enter. note If a power outage occurs when Direct Power On is enabled and the projector is plugged in, the projector will start when the power is restored. 4. Highlight On and press Enter. 5. Press Esc or Menu to exit. The setting will take effect the next time you plug in the projector. 26 Displaying and Adjusting the Image