HP 3500cp Service Manual - Page 135
C10. Font Type Set Only available in DesignJet 2500CP/3500CP
View all HP 3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
C10. Font Type Set (Only available in DesignJet 2500CP/3500CP printer) YOU SHOULD ONLY NEED TO SET THE FORNT TYPE IF YOU REQUIRE ASIAN FONTS, OTHERWISE IT SHOULD NEVER BE USED. The purpose of this calibration is to check and, if necessary, select a Font type. NOTE FOR HP DESIGNJETS 2500CP WITH FIRMWARE VERSION LOWER THAN A.02.14: IT IS HIGHLY RECOMMENDED THAT YOU UPGRADE THE FIRMWARE INSTEAD OF REPLACING BOTH THE HARD DISK DRIVE AND THE ELECTRONICS MODULE. NOTE FOR HP DESIGNJET 2500CP WITH FIRMWARE VERSION A.02.14 OR HIGHER AND HP DESIGNJET 3500CP: YOU MUST PERFORM THIS CALIBRATION WHEN YOU INSTALL A NEW ELECTRONICS MODULE IN ORDER TO SET THE CORRECT FONT TYPE. IF YOU NEED TO DEFINE THE FONT TYPE BUT THIS CALIBRATION DOES NOT ALLOW YOU TO SELECT THE REQUIRED FONT TYPE, THEN YOU MUST PERFORM THE TEST D17. RESET COUNTERS" ON PAGE ' 4Ć30 TO RESET THE COUNTERS TO ZERO AND THEN REDO THIS CALIBRATION. Perform the Font Type Set Calibration as follows: 1 In the Calibrations submenu, scroll to C10 Font Type Set" and press Enter. Calibrations C10 Font Type Set 2 If you have not installed a new Electronics Module, the current font type will be displayed on the frontĆpanel. 3 If you have installed a new Electronics Module (counter plots = 0), the message Character Set New" will be displayed on the frontĆpanel. Press the Up Arrow key to set the new type font. Service Calibrations HP DesignJet CP Series Printers 5-19