HP 3500cp Service Manual - Page 236

Front Panel and StandĆby Button Refer to figure 7 ' page 8Ć25 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Window and Top Cover ' page 8Ć15. 2. Right Hand Cover ' page 8Ć21. 2. Remove the standĆby button cable and the front panel cable from the wire clamps (item 1) on the inside of the right hand cover. 3. Remove the front panel (item 2) from inside the right hand cover (item 3) by releasing it from the retaining clips. 4. Open the door (item 4) on the right hand cover. 5. Remove the standĆby button (item 5) by releasing it from the securing clips located inside the right hand cover. 6. Remove the standĆby button through the front of the right hand cover. Installation 1. Open the door (item 4) on the right hand cover. Feed the cable for the standĆby button (item 5) through a hole in the front of the right hand cover (item 3). 2. Secure the button in the cover by pushing it onto retaining clips. 3. Push the front panel (item 2) into the securing clips inside the right hand cover. 4. Route the standĆby button cable and the front panel cable through cable clamps (item 1) on the inside of the right hand cover. 5. Install the following: 1. Right Hand Cover ' page 8Ć21. 2. Window and Top Cover ' page 8Ć15. 6. Connect the power cord and turn the printer on in service mode. 7. Perform D07 Front Panel Service Test ' page 4Ć17 8-24 HP DesignJet CP Series Printers Removal and Installation