HP 3500cp Service Manual - Page 233
Right Hand Cover and Right Hand Trim Assembly, Switch off the printer and remove the power cable.
View all HP 3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
Right Hand Cover and Right Hand Trim Assembly Refer to figure 6 ' page 8Ć23 Removal 1. Remove the ink delivery system (Refer to the User Guide). WARNING Switch off the printer and remove the power cable. 2. Remove the left hand back cover. 3. Disconnect the front panel cable from position J1 FRONT PANEL on the electronics module. 4. Disconnect the standĆby button cable from position J2 ON/STBY on the electronics module. 5. Remove the following: 1. Window and Top Cover ' page 8Ć15. 6. Open the door on the right hand cover (item 1). Note: Position the pinchĆarm lever at half way to enable you to perform the next step (item 2). 7. Remove the right hand trim assembly (item 3) by removing five TĆ15 screws (item 4) and disconnecting two cover sensors (item 5) located on the inside. Be careful not to drop the cover (item 7) once the securing fasteners have been removed. Support the cover throughout the next step. The right hand cover and window sensors can be removed by disconnecting them from the front panel assembly. 8. Remove the three TĆ15 screws (item 6) securing the right hand cover to the right hand side chassis. 9. Remove the right hand cover (item 7), carefully passing the front panel cable and the standĆby button cable through the hole in the right hand side chassis. Removal and Installation HP DesignJet CP Series Printers 8-21