HP 3500cp Service Manual - Page 252

Installation 1. Install the YĆaxis belt (item 3) onto the carriage assembly making sure the belt is in between the two slider rods (see figure 14, item 5). 2. Install the carriage assembly ' page 8Ć42 Note: Make sure the YĆaxis belt is not twisted. 3. Install the YĆaxis belt (item 3) around the YĆaxis belt pulley (item 6). 4. Install the YĆaxis belt pulley with the belt into the YĆaxis tensioner holder (item 2). 5. Install the belt around the YĆaxis motor pulley (item 5). WARNING The spring is under high tension and could spring out of the YĆaxis tensioner holder. Caution: Cup your hand over the YĆaxis tensioner holder in the next step to avoid losing the spring. 6. If you have removed the tensioner wedge clip (item 4) and the spring (item 1), install it now. To tension the belt, use a small flatĆblade screw driver to release the wedge tensioner clip from its position in the YĆaxis tensioner holder. 7. Install the following: 1. Left Hand Cover ' page 8Ć18. 2. Right Hand Cover ' page 8Ć21. 3. Window and Top Cover ' page 8Ć15. 8. Install the power cable. 8-40 HP DesignJet CP Series Printers Removal and Installation