HP 3500cp Service Manual - Page 230

Left Hand Cover and Left Hand Trim Assembly Refer to figure 5 ' page 8Ć20 Removal 1. Remove the ink delivery system (Refer to the User Guide). WARNING Switch off the printer and remove the power cord. 2. Remove the following: 1. Window and Top Cover ' page 8Ć15. 3. Open the door on the left hand cover (item 1). 4. Remove the left hand trim assembly (item 2) by removing four TĆ15 screws (item 3) and one TĆ20 screw (item 4) and disconnecting the cover sensor (item 5). Be careful not to drop the cover once the securing fasteners have been removed. Support the cover throughout the next step. 5. Remove the three TĆ15 screws (item 6) securing the cover to the left hand side chassis. 6. Making sure the left hand door is open, remove the left hand cover (item 7). Note: To remove the Cover Sensor, disconnect it from position J6 DOOR SW on the Refill Interconnect PCA. 8-18 HP DesignJet CP Series Printers Removal and Installation