HP 3500cp Service Manual - Page 267
J4 VALVE SENSOR, J6 DOOR SW, J3 REFILL SENSOR, Refill Sensor Cable in position
View all HP 3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
Refill Assembly Refer to figure 19 ' page 8Ć57 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Window and Top Cover page ' 8Ć15. 2. Left Hand Cover ' page 8Ć18. 2. Disconnect the following cables from the refill interconnect PCA (item 1): 1. Valve sensor cable in position J4 VALVE SENSOR 2. Door Sensor cable in position J6 DOOR SW 3. Refill Sensor Cable in position J3 REFILL SENSOR 3. Remove the cables from two cable clamps (item 2) on the left hand side chassis. 4. Carefully disconnect from the refill stepper motor the refill stepper motor cable (item 3). 5. Remove the cable clamp securing the cables to the YĆaxis bracket. 6. Loosen fully the three TĆ20 screws (item 4) from the refill assembly. 7. Remove the TĆ20 screw (item 5) at the end of the metal rod securing it to the YĆaxis bracket (item 6). 8. Remove the refill assembly (item 7). Removal and Installation HP DesignJet CP Series Printers 8-55