HP 3500cp Service Manual - Page 262
Cutter Assembly Only Applicable to, HP DesignJets 3500CP and 3000CP, Refer to B
View all HP 3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 262 highlights
Cutter Assembly (Only Applicable to HP DesignJets 3500CP and 3000CP) Refer to figure 17B ' page 8Ć51 Removal WARNING Switch off the printer and remove the power cord. 1. Remove the following: 1. Right Hand Cover ' page 8Ć21. 2. Move the Carriage Assembly to the right. 3. Loosen the screw (item 1) located on the right end of the Starguard. 4. Remove the cutter assembly (item 2) from the slider rod by sliding it to the right and pulling it off the rear bushing (item 3). Installation Note: Make sure that when you install the Cutter Assembly that both black wheels of the cutter assembly enter the starguard assembly. 1. Install the cutter assembly (item 2) onto the rear bushing (item 3) and slide to the left. To obtain the correct position so that the cutter assembly moves easily into position, you may have to move the cutter wheel (which is sprung loaded). 2. Tighten the screw (item 1) located on the right end of the Starguard assembly onto the overdrive assembly. 3. Install the following: 2. Right Hand Cover ' page 8Ć21. 4. Install the power cable and turn the printer on in service mode. 5. Perform D10 Cutter Service Test ' page 4Ć22 8-50 HP DesignJet CP Series Printers Removal and Installation