HP 3500cp Service Manual - Page 297

Installation of the pincharm sensor. 1. Install the pincharm sensor into the correct position and secure with two TĆ10 screws (item 1). 2. Install the pincharm sensor cable into the cable clamp (item 2) secured to the left hand side chassis. 3. Connect the pincharm sensor cable to the electronics module in position J8 PINCH. 4. Install the following: 1. Right Hand Cover ' page 8Ć21. 2. Service Station Assembly ' page 8-26 5. Connect the power cord and turn the printer on in service mode. 6. Perform D08 Sensor Service Test ' page 4Ć28 Installation of the pincharm assemblies and the pincharm shaft. 1. Install the pincharm shaft (item 6) into the left hand side chassis and at the same time install the pincharm spring (item 8) and pincharm assemblies (item 7) into the plastic bushing (item 9) in the chassis. 2. Install the cam journal (item 4) onto the pincharm shaft on the right hand side chassis. 3. Making sure that you do not over tighten the screw, secure the cam journal on the end of the pincharm shaft with the TĆ9 screw (item 3). 4. Install the top half of the elevator assembly by securing it to two retaining clips at the back and push down and to the right. 5. Install the following: 1. Overdrive Assembly and Drive Roller ' page 8Ć69. 2. Service Station Assembly ' page 8Ć26. 3. Left Hand Cover ' page 8Ć18. 4. Right Hand Cover ' page 8Ć21. 5. Window and Top Cover ' page 8Ć15. 6. Connect the power cord and turn the printer on in service mode. 7. Perform D08 Sensor Service Test ' page 4Ć28 Removal and Installation HP DesignJet CP Series Printers 8-85