HP 4650n HP Color LaserJet 4650 series printer - User Guide - Page 185
Replace Transfer Kit, Transfer Kit
UPC - 829160046532
View all HP 4650n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
Control panel messages (continued) Control panel message Description Recommended action REPLACE TRANSFER KIT For help press The transfer unit is at end of life. Printing will not continue until the transfer kit has been replaced. 1. Open the top and front cover. 2. Remove the old unit by pressing the blue buttons on either side of the unit. 3. Slide the old unit out of the printer. 4. Install a new transfer unit. 5. Close the front and top covers. 6. Supplies ordering information is also available from the embedded Web server. See Using the embedded Web server for more information. Note If the old transfer unit was not at end-oflife when it was replaced (for example, if it was damaged), or if you want to continue printing past the end-of-life message, the transfer unit count must be reset using the printer control panel. Please note that the end-of-life message is provided as a customer service, and printing past it is likely to result in print quality degradation in the near future. Once the transfer kit count has been reset after an end-of-life message, feedback on the kit's remaining life will be incorrect until the kit is replaced and the count is reset again. To reset the transfer unit count 1. Press MENU to enter the MENUS. 2. Press and to highlight CONFIGURE DEVICE. 3. Press to select CONFIGURE DEVICE. 4. Press and to highlight RESETS. 5. Press to select RESETS. 6. Press and to highlight RESET SUPPLIES. 7. Press to select RESET SUPPLIES. 8. Press and to highlight NEW TRANSFER KIT. 9. Press to select NEW TRANSFER KIT. 10. Press and to highlight YES. 11. Press to select YES. The transfer unit count is reset and the printer is ready to use. ENWW Control panel messages 171