HP 6125XLG R2306-HP 6125XLG Blade Switch FCoE Configuration Guide - Page 108
Create interface VFC 1, and con it to operate in E mode., Con a static route.
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
system-view [SwitchB] fcoe-mode fcf [SwitchB] vsan 1 [SwitchB-vsan1] domain configure enable # Configure the domain ID as 2. [SwitchB-vsan1] domain-id 2 static Non-disruptive reconfiguration or isolating the switch may be performed. Continu e? [Y/N]:y # Disable FSPF globally. [SwitchB-vsan1] undo fspf enable # Configure a static route. [SwitchB-vsan1] fc route-static 010000 8 vfc 1 [SwitchB-vsan1] quit # Create interface VFC 1, and configure it to operate in E mode. [SwitchB] interface vfc 1 [SwitchB-Vfc1] fc mode e # Bind interface VFC 1 to interface Ten-GigabitEthernet 1/1/5, and assign it to VSAN 1 as a trunk port. [SwitchB-Vfc1] bind interface ten-gigabitethernet 1/1/5 [SwitchB-Vfc1] port trunk vsan 1 [SwitchB-Vfc1] quit # Assign interface Ten-GigabitEthernet 1/1/5 to VLAN 10 as a trunk port. [SwitchB] interface ten-gigabitethernet 1/1/5 [SwitchB-Ten-GigabitEthernet1/1/5] port link-type trunk [SwitchB-Ten-GigabitEthernet1/1/5] port trunk permit vlan 10 [SwitchB-Ten-GigabitEthernet1/1/5] quit # Create interface VFC 2, and configure it to operate in E mode. [SwitchB] interface vfc 2 [SwitchB-Vfc2] fc mode e # Bind interface VFC 2 to interface Ten-GigabitEthernet 1/1/6, and assign it to VSAN 1 as a trunk port. [SwitchB-Vfc2] bind interface ten-gigabitethernet 1/1/6 [SwitchB-Vfc2] port trunk vsan 1 [SwitchB-Vfc2] quit # Assign interface Ten-GigabitEthernet 1/1/6 to VLAN 10 as a trunk port. [SwitchB] interface ten-gigabitethernet 1/1/6 [SwitchB-Ten-GigabitEthernet1/1/6] port link-type trunk [SwitchB-Ten-GigabitEthernet1/1/6] port trunk permit vlan 10 [SwitchB-Ten-GigabitEthernet1/1/6] quit # Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1. [SwitchB] vlan 10 [SwitchB-vlan10] fcoe enable vsan 1 [SwitchB-vlan10] quit 3. Configure Switch C: # Configure Switch C to operate in advanced mode, save the configuration, and reboot Switch C. (Skip this step if the switch is operating in advanced mode.) 102