HP 6125XLG R2306-HP 6125XLG Blade Switch FCoE Configuration Guide - Page 47
with the logic OR operator, and specify ACL 4000 as the match, Create a behavior named
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Non-disruptive reconfiguration or isolating the switch may be performed. Continu e? [Y/N]:y [SwitchC-vsan1] quit # Enable LLDP globally. [SwitchC] lldp global enable # Enable LLDP on interface Ten-GigabitEthernet 1/1/7, and enable the interface to advertise DCBX TLVs. [SwitchC] interface ten-gigabitethernet 1/1/7 [SwitchC-Ten-GigabitEthernet1/1/7] lldp enable [SwitchC-Ten-GigabitEthernet1/1/7] lldp tlv-enable dot1-tlv dcbx [SwitchC-Ten-GigabitEthernet1/1/7] quit # Create an Ethernet frame header ACL numbered 4000, and configure two rules to match FCoE frames (protocol type 0x8906) and FIP frames (protocol type 0x8914). [SwitchC] acl number 4000 [SwitchC-acl-ethernetframe-4000] rule permit type 8906 ffff [SwitchC-acl-ethernetframe-4000] rule permit type 8914 ffff [SwitchC-acl-ethernetframe-4000] quit # Create a class named app_c with the logic OR operator, and specify ACL 4000 as the match criterion. [SwitchC] traffic classifier app_c operator or [SwitchC-classifier-app_c] if-match acl 4000 [SwitchC-classifier-app_c] quit # Create a behavior named app_b, and configure the action of marking packets with 802.1p priority 3. [SwitchC] traffic behavior app_b [SwitchC-behavior-app_b] remark dot1p 3 [SwitchC-behavior-app_b] quit # Create a QoS policy named plcy, and associate the class app_c with the behavior app_b in the QoS policy, specifying that the class-behavior association applies only to DCBX. [SwitchC] qos policy plcy [SwitchC-qospolicy-plcy] classifier app_c behavior app_b mode dcbx [SwitchC-qospolicy-plcy] quit # Apply the QoS policy plcy to the outbound direction of interface Ten-GigabitEthernet 1/1/7. [SwitchC] interface ten-gigabitethernet 1/1/7 [SwitchC-Ten-GigabitEthernet1/1/7] qos apply policy plcy outbound [SwitchC-Ten-GigabitEthernet1/1/7] quit # Configure the mapping from 802.1p priority 3 to local precedence 3 in the outbound direction. (This is the default, and you can modify the mapping as needed.) [SwitchC] qos map-table dot1p-lp [SwitchC-maptbl-out-dot1p-lp] import 3 export 3 [SwitchC-maptbl-out-dot1p-lp] quit # Enable byte-count WRR on interface Ten-GigabitEthernet 1/1/7, and configure queue 3 to use SP queuing. [SwitchC] interface ten-gigabitethernet 1/1/7 [SwitchC-Ten-GigabitEthernet1/1/7] qos wrr byte-count [SwitchC-Ten-GigabitEthernet1/1/7] qos wrr 3 group sp 41