HP LH4r HP Netserver LXr 8000 Installation Guide - Page 29
Opening and Closing the, HP NetServer
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
3 Opening and Closing the HP NetServer Removing and Replacing the Front Bezel The front bezel has three clips that mount onto a hinge. The hinge is secured to the front of the HP NetServer. You can swing the bezel open on its hinge, or remove the bezel entirely. To swing the bezel open, grasp it by the handle on its right edge and pull it open to the left. This exposes the mass storage bay and the memory board bays. To remove the bezel, pull it straight forward off the chassis. To replace the chassis, press it back onto the chassis so that it snaps into place. See Figure 3-1. Figure 3-1. Removing and Replacing the HP NetServer's Front Bezel NOTE HP NetServers installed in non-HP racks use a different front bezel that mounts differently. For more infomation, refer to the separate rack-mounting guide for third-party racks. It is 21