HP LH4r HP Netserver LXr 8000 Installation Guide - Page 64
Screw the board's I/O bracket to the HP NetServer's I/O panel.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Chapter 6 Installing Additional Boards 9. Push the board down into its connector on the I/O baseboard. See Figure 6-4. Figure 6-4. Inserting the Board 10. Screw the board's I/O bracket to the HP NetServer'sI/O panel. If the board is in one of the PCI Hot Plug slots (P7 through P10): a. Put the board's I/O bracket in place on the I/O panel. Line the screw hole on the bracket up with the matching hole on the I/O panel, but do not screw it in. b. Replace the Hot Plug board bracket. It fits over the board's own I/O bracket. The captive screw in the Hot Plug board bracket must line up with the screw hole in the board's I/O bracket and the matching hole on the server. c. Fasten both brackets in place with the captive screw. See Figure 6-5. 56
Chapter 6
Installing Additional Boards
56
9.
Push the board down into its connector on the I/O baseboard. See Figure
6-4.
Figure 6-4. Inserting the Board
10.
Screw the board’s I/O bracket to the HP NetServer’s I/O panel.
If the board is in one of the
PCI Hot Plug slots (P7 through P10):
a.
Put the board’s I/O bracket in place on the I/O panel. Line the screw
hole on the bracket up with the matching hole on the I/O panel, but do
not screw it in.
b.
Replace the Hot Plug board bracket. It fits over the board’s own I/O
bracket. The captive screw in the Hot Plug board bracket must line up
with the screw hole in the board’s I/O bracket and the matching hole
on the server.
c.
Fasten both brackets in place with the captive screw. See Figure 6-5.