HP LH4r HP Netserver LXr 8000 Installation Guide - Page 50
for the other board.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Chapter 5 Installing Additional Memory 7. The memory boards sit side by side underneath the processor baseboard. Choose the board you want to remove, and pull open the two retaining latches that hold it in place. See Figure 5-7. Retaining Latches 1. Pull open retaining latches on memory board. 2. Pull board from its slot Figure 5-7. Removing and Replacing a Memory Board 8. Hold the memory board by the corners, and carefully pull the board from its slot. See Figure 5-7. NOTE If you need to remove both memory boards, repeat steps 7 and 8 for the other board. 9. Place the memory board component-side up on a firm, anti-static surface for protection. 10. Install or remove DIMMs as described in later in this chapter. 42
Chapter 5
Installing Additional Memory
42
7.
The memory boards sit side by side underneath the processor baseboard.
Choose the board you want to remove, and pull open the two retaining
latches that hold it in place. See Figure 5-7.
Retaining
Latches
1. Pull open retaining
latches on memory
board.
2. Pull board from
its slot
Figure 5-7. Removing and Replacing a Memory Board
8.
Hold the memory board by the corners, and carefully pull the board from
its slot. See Figure 5-7.
NOTE
If you need to remove both memory boards, repeat steps 7 and
8 for the other board.
9.
Place the memory board component-side up on a firm, anti-static surface
for protection.
10.
Install or remove DIMMs as described in later in this chapter.