HP LH4r HP Netserver LXr 8000 Installation Guide - Page 52
Installing DIMMs on a Memory Board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Chapter 5 Installing Additional Memory Installing DIMMs on a Memory Board Follow these steps to install a DIMM in a slot on a memory board. CAUTION Use only DIMMs acquired from HP. Contact HP Customer Support for a list of qualified DIMMs. HP will not support configurations that use non-HP Buffered EDO DIMMs. 1. Remove the memory board from the computer. See the previous section, "Removing and Replacing the Memory Board." 2. Place the board on a firm, anti-static surface. The side of the board that holds the components must face up. 3. Remove a DIMM (Figure 5-10) from its container, handling the module by its edges. Lay it on an anti-static surface. Figure 5-10. A DIMM Module 4. Locate the slot where you will install the DIMM. (See Figures 5-4 and 5-5 for recommended DIMM configurations.) Spread the slot's two DIMM retaining clips outward. See Figure 5-11. 44