HP LH4r HP Netserver LXr 8000 Installation Guide - Page 91
NetServer, make sure that the leveler screws on the rack's
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Chapter 8 Mounting the Server in the Rack WARNING With power supplies in place, the HP NetServer does not balance evenly when lifted by its handles. Two people may have difficulty holding the HP NetServer level enough to fasten it to the slides. Removing the power supplies improves the balance of the HP NetServer and reduces the likelihood of accidents. 2. Pull out both slides until their slide members are fully extended (Figure 8-7). When you do this, the slides lock into position. You cannot push them back in the rack without pressing in their release latches (Figure 8-10). Slide Member Slide Member Figure 8-7. Pulling Out the Slides WARNING To prevent the rack from rolling while you mount the HP NetServer, make sure that the leveler screws on the rack's lower four corners are in firm contact with the floor. 83