HP LH4r HP Netserver LXr 8000 Installation Guide - Page 44
Bank A Slots J1, J2, J3, J4, Bank B Slots J5, J6, J7, J8, Bank C Slots J9, J10, J11, J12, Bank D
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Chapter 5 Key: Installing Additional Memory Bank A (Slots J1, J2, J3, J4) Bank B (Slots J5, J6, J7, J8) Bank C (Slots J9, J10, J11, J12) Bank D (Slots J13, J14, J15, J16) J1 J2 J5 J6 J9 J10 J13 J14 J3 J4 J7 J8 J11 J12 J15 J16 Figure 5-3. DIMM Slot Numbers and Bank Numbers Please note the following DIMM installation guidelines before adding memory: • Add (or remove) DIMMs to the memory board in groups of four. Each group of four DIMMs must fill one bank on a memory board. A bank must be either fully populated or completely empty. See Figure 5-3. • When populating a memory board, fill Bank A first, then Bank B, then Bank C, and finally Bank D. You must do this if a board is to have four-way interleaving. 36
Chapter 5
Installing Additional Memory
36
Bank A (Slots J1, J2, J3, J4)
Bank B (Slots J5, J6, J7, J8)
Bank C (Slots J9, J10, J11, J12)
Bank D (Slots J13, J14, J15, J16)
Key:
J1
J2
J5
J6
J9
J10
J13
J14
J3
J4
J7
J8
J11
J12
J15
J16
Figure 5-3. DIMM Slot Numbers and Bank Numbers
Please note the following DIMM installation guidelines before adding memory:
•
Add (or remove) DIMMs to the memory board in groups of four
.
Each group of four DIMMs must fill one bank on a memory board. A
bank must be either fully populated or completely empty. See Figure 5-3.
•
When populating a memory board, fill Bank A first, then Bank B,
then Bank C, and finally Bank D.
You must do this if a board is to have
four-way interleaving.