HP LH4r HP Netserver LXr 8000 Installation Guide - Page 88
Step 2: Attaching the Slides to the Rack
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Chapter 8 Mounting the Server in the Rack # # # # # Left Rear of Rack Right "#" represents the EIA unit numbers on the rack columns Attach nuts to this face of the rear columns Bottom of Server Sixth Hole From Bottom Fourth Hole From Bottom Figure 8-4. Rack Nut Locations on the Rack's Rear Columns Step 2: Attaching the Slides to the Rack 1. Pull the stabilizing foot forward out of the bottom of the rack. Figure 8-5 shows the stablizing foot. 2. Hold a slide in position inside the two left-hand rack columns: a. The mounting flange on each end must wrap around the outside face of both the front and rear columns. See Figure 8-5. b. The two holes in the mounting flange should line up with the two lowest rack nuts you installed on each column. c. The end of the slide that extends -- the slide member -- should point forward out of the rack. 80