HP LH4r HP Netserver LXr 8000 Installation Guide - Page 49
The memory bays are protected by an access panel. Loosen the three, captive screws that hold
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Chapter 5 Installing Additional Memory 1. Pull up on LCD handle. LCD slides up about 1/2 inch Memory Access Panel 2. Loosen captive screws on memory access panel. Remove panel. Captive Screws Figure 5-6. Gaining Access to the Memory Board Bays 6. The memory bays are protected by an access panel. Loosen the three captive screws that hold the panel in place, and then remove the panel. See Figure 5-6. 41
Chapter 5
Installing Additional Memory
41
Captive
Screws
1. Pull up on LCD
handle. LCD slides
up about 1/2 inch
2. Loosen captive screws
on memory access
panel. Remove panel.
Memory
Access
Panel
Figure 5-6. Gaining Access to the Memory Board Bays
6.
The memory bays are protected by an access panel. Loosen the three
captive screws that hold the panel in place, and then remove the panel.
See Figure 5-6.