HP LH4r HP Netserver LXr 8000 Installation Guide - Page 35
Installing Mass Storage Devices
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
4 Installing Mass Storage Devices Introduction The HP NetServer supports Fast/Wide SCSI for internal devices. Ultra-SCSI devices, if installed, run as Fast/Wide devices. The internal CD-ROM drive is an IDE device. The HP NetServer accepts these mass storage devices: • Hewlett Packard hot-swap SCSI hard disk drives • CD-ROM and tape drives • Flexible disk drive NOTE Some devices, including some DAT drives, may need an adapter to connect to the server's internal SCSI cable. A 68-pin-to-50-pin SCSI adapter is attached to to the SCSI cable in the tape drive bay. If your system was not configured with a DAT, the cable is terminated. (The terminator is clamped to the rear of the tape drive bay filler panel.) This chapter describes how to install internal SCSI hot-swap hard disks. Installation Basics Boot Device Priority By default, the HP NetServer searches for bootable devices in the order shown below. (This boot sequence is configurable.) 1. IDE CD-ROM drive 2. Flexible disk drive 3. ISA board 4. Slot P1 5. On-board SCSI 27