HP XM600 hp kayak xm600 series 1, user's guide for minitower models - Page 23
Removing and Replacing the Cover and Front Bezel, Removing the, Cover, Front Bezel
View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
2 Installing and Replacing Hardware Parts in Your PC Workstation Removing and Replacing the Cover and Front Bezel Removing the Cover Removing and Replacing the Cover and Front Bezel For your own safety, it is recommended that you first read the warning notices on pages 6 and 7. 1 Switch off the display and computer. Disconnect all power cables and any LAN or telecommunications cables. 2 Unscrew the two thumb screws located at the back of the PC Workstation. 3 Standing at the back of the PC Workstation, slide the cover towards you until it clicks into place. 4 Tilt the cover sidewards, then lift off the PC Workstation chassis. Removing the Front Bezel 5 If required, remove the front bezel which is divided into two sections: • The upper bezel (blue) gives access to three 5.25-inch shelves and two 3.5-inch shelves. • The lower bezel (grey) gives access to the control panel. To access the lower bezel, you must first remove the upper bezel. 23