IBM 9228 Service Guide - Page 112
POST error codes, Cache Control
UPC - 000435947840
View all IBM 9228 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
POST error codes The following table describes the POST error codes and suggested actions to correct the detected problems. Table 7. POST error codes v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 9228 and 9232," on page 19 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error code Description Action 062 The computer failed to start on three 1. Run the Configuration/Setup Utility program and consecutive attempts. make sure that all settings are correct. Use the All caches are disabled. Repeatedly turning the computer on and off or resetting the computer might cause this problem. Cache Control selection in the Advanced Setup menu of the Configuration/Setup Utility program to enable the caches. 2. Reseat the following components: a. Battery b. (Trained service technician only) Microprocessor 3. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Battery b. (Trained service technician only) Microprocessor c. (Trained service technician only) System board Note: When the problem is corrected, be sure to enable the caches. 101 Timer tick interrupt failure. (Trained service technician only) Replace the system board. 102 Timer 2 test failure. (Trained service technician only) Replace the system board. 106 Diskette control error. (Trained service technician only) Replace the system board. 129 An internal cache (L1) error occurred. 1. (Trained service technician only) Reseat the microprocessor. 2. (Trained service technician only) Reseat the optional microprocessor. 3. Replace the following components one at a time, in the order shown, restarting the computer each time: a. (Trained service technician only) Microprocessor b. (Trained service technician only) Optional microprocessor 94 IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide