IBM 9228 Service Guide - Page 119
Devices and I/O Ports, Run the Configuration/Setup Utility program, select
![]() |
UPC - 000435947840
View all IBM 9228 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Table 7. POST error codes (continued) v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 9228 and 9232," on page 19 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error code Description Action 178x An error occurred during the hard disk drive x test (x = 0 to 3). 1. Reseat the hard disk drive x cable. 2. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Hard disk drive x b. Hard disk drive cable x c. (Trained service technician only) System board 1800 No more hardware interrupt available for the 1. Run the Configuration/Setup Utility program. PCI adapter. 2. Remove the adapter. 1808 Unsupported PCI device is installed. 1. Run the Configuration/Setup Utility program, select Devices and I/O Ports, and make sure that the device is enabled. 2. Reseat each adapter. Note: If an error LED is lit on an adapter, reseat that adapter first; if no LEDs are lit, reseat each adapter one at a time, restarting the computer each time, to isolate the failing adapter. 3. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Failing adapter b. (Trained service technician only) System board Chapter 5. Diagnostics 101
![](/manual_guide/products/ibm-9228-service-guide-dc2b35d/119.png)