IBM 9228 Service Guide - Page 85
Removing and replacing FRUs, Removing the front adapter-retention bracket, cables and power cords.
![]() |
UPC - 000435947840
View all IBM 9228 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Removing and replacing FRUs FRUs must be installed only by trained service technicians. The illustrations in this document might differ slightly from the hardware. Removing the front adapter-retention bracket To remove the front adapter-retention bracket, complete the following steps. Release tab Front view Pivot points Rear view Figure 43. Removing front adapter-retention bracket 1. Read the safety information that begins on page vii and "Installation guidelines" on page 29. 2. Turn off the computer and all attached devices; then, disconnect all external cables and power cords. 3. Remove the side cover (see "Removing the side cover" on page 31). Note: It might be helpful to lay the computer on its left side for the remainder of this procedure. Chapter 4. Removing and replacing computer components 67
![](/manual_guide/products/ibm-9228-service-guide-dc2b35d/85.png)