IBM 9228 Service Guide - Page 82
Installing the power switch/LED assembly
UPC - 000435947840
View all IBM 9228 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Installing the power switch/LED assembly To install the power switch/LED assembly, complete the following steps. Release tab Figure 40. Installing the power switch/LED assembly 1. From inside the chassis, push the power switch/LED assembly toward the front of the chassis until the assembly engages the power switch release tab and clicks into place (see Figure 39). 2. Reconnect the power switch/LED assembly cable to the system board. 3. If an optical drive is in bay 1, push the drive into the drive bay, until it snaps in place. 4. Install the front bezel (see "Installing the two-piece bezel" on page 35). 5. Install the side cover (see "Installing the side cover" on page 32). 6. Reconnect the external cables and power cords; then, turn on the attached devices and the computer. 64 IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide