IBM 9228 Service Guide - Page 118
Run the Configuration/Setup Utility program
UPC - 000435947840
View all IBM 9228 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Table 7. POST error codes (continued) v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 9228 and 9232," on page 19 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service technician. Error code Description Action 662 A diskette drive configuration error occurred. 1. Run the Configuration/Setup Utility program and diagnostics. 2. Reseat the diskette drive cable. 3. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Diskette drive cable b. Diskette drive c. (Trained service technician only) System board 1162 The serial port configuration conflicts with another device in the system. 1. Make sure that the interrupt request (IRQ) and I/O port assignments needed by the serial port are available. 2. If all interrupts are being used by adapters, remove an adapter to make an interrupt available to the serial port, or force other adapters to share an interrupt. 3. Make sure that the serial port setting is correct in the Configuration/Setup Utility program. If the setting is not correct, change it and save the settings. 4. (Trained service technician only) Replace the system board. 11xx A system board serial port 1 error occurred (xx can be any number or letter). 1. Run the Configuration/Setup Utility program. 2. (Trained service technician only) Replace the system board. 1601 A BIOS code update is required. 1. Download and install the latest level of the BIOS code. 2. (Trained service technician only) Replace the system board. 1762 A hard disk drive configuration error occurred. 1. Make sure that the hard disk drive is set correctly in the Configuration/Setup Utility program. 2. Reseat the hard disk drive cable. 3. Replace the following components one at a time, in the order shown, restarting the computer each time: a. Hard disk drive b. Hard disk drive cable c. (Trained service technician only) System board 100 IBM IntelliStation Z Pro Type 9228 and 9232: Problem Determination and Service Guide