IBM x3400 Installation Guide - Page 22
Major, components, server - power cage
View all IBM x3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Major components of the server Note: The major components of the server vary, depending on the machine type and model. Blue on a component indicates touch points, where you can grip the component to remove it from or install it in the server, open or close a latch, and so on. Orange on a component or an orange label on or near a component indicates that the component can be hot-swapped, which means that if the server and operating system support hot-swap capability, you can remove or install the component while the server is running. (Orange can also indicate touch points on hot-swap components.) See the instructions for removing or installing a specific hot-swap component for any additional procedures that you might have to perform before you remove or install the component. The following illustration shows the major components in the server. Note: The illustrations in this document might differ slightly from your hardware. Hot-swap power supply Fixed power supply Hot-swap power supply filler Power supply cage DIMM air duct Rear adapter retention bracket Heat sink retention bracket DIMMs Microprocessor Heatsink Control panel assembly Drive bay EMC shield USB cable assembly DVD drive Heat sink filler SAS/SATA backplane Fan SATA assembly backplate Hot-swap fan Processor baffle System board Hard disk drive EMC shield Bezel Simple-swap drive ServeRAID 8k-1 VRM Cover Hot-swap drive DVD drive trim piece Hot-swap drive trim piece Simple-swap drive trim piece 8 System x3400 Types 7973, 7974, 7975, and 7976: Installation Guide