IBM x3400 Installation Guide - Page 45
Completing, installation, Replacing, bezel
View all IBM x3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Completing the installation To complete the installation, you must replace the bezel, reinstall the side cover, and connect all the cables and, for certain options, run the Configuration/Setup Utility program. Follow the instructions in this section. Replacing the bezel To replace the bezel, complete the following steps: 1. Align the hinge assembly with the hinge holes on the chassis. Bezel Hinge assembly Retention tabs 2. Push the hinges into the holes on the chassis until they snap into place. 3. If however, the bezel was removed by detaching the sliding hinge mount from the hinge assembly (using the breakaway method as the bezel was designed to do), complete the following steps to reattach the bezel: a. Press in on the rear of the sliding hinge mount until it extends beyond the edge of the bezel and hold it in place. Chapter 2. Installing options 31