IBM x3400 Installation Guide - Page 27
Removing, bezel
View all IBM x3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Removing the bezel Important: Before you install optional hardware, make sure that the server is working correctly. Start the server, and make sure that the operating system starts, if an operating system is installed, or that a 19990305 error code is displayed, indicating that an operating system was not found but the server is otherwise working correctly. If the server is not working correctly, see the Problem Determination and Service Guide for diagnostic information. To remove the bezel, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 9. 2. Unlock the side cover. Note: You must unlock the side cover to remove the bezel. 3. Position your finger on the depressed area on the left side of the bezel and rotate the bezel away from the server. 4. Press the retention tabs on the hinge assembly toward each other and pull the hinge assembly out of the chassis. Chapter 2. Installing options 13