IBM x3400 Installation Guide - Page 49
Updating, server, configuration - video driver
View all IBM x3400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
The following illustration shows the input/output (I/O) connectors on the rear of the non-hot-swap power supply models. Power cords Mouse Keyboard Serial 1 (COM 1) Parallel Video USB 4 USB 3 (RJ45) Ethernet 10/100/1000 (RJ45) Ethernet 10/100 (for Remote Supervisor Adapter II SlimLine) NMI button Serial 2 (COM 2) Updating the server configuration When you start the server for the first time after you add or remove an internal option or an external device, you might receive a message that the configuration has changed. The Configuration/Setup Utility program starts automatically so that you can save the new configuration settings. For additional information, see "Using the Configuration/Setup Utility program" on page 46. Some options have device drivers that you must install. See the documentation that comes with each option for information about installing device drivers. If the server has an optional ServeRAID adapter and you have installed or removed a hard disk drive, see the documentation that comes with the ServeRAID adapter for information about reconfiguring the disk arrays. If you have installed an optional Remote Supervisor Adapter II SlimLine to manage the server remotely, see the Remote Supervisor Adapter II SlimLine documentation that comes with the adapter for information about setting up, configuring, and using the adapter. Chapter 2. Installing options 35