Kenmore 19110 Owners Manual - Page 75
E:i E:21
UPC - 883073000043
View all Kenmore 19110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Darning Machine setting _i_ Pattern _2_LED display _3_Foot R: Automatic buttonhole foot [iiq Pull the button holder fully to the back. [ii_ Draw the needle thread to the left through the hole on the foot. [i_i1Lower the needle into the fabric at starting point. Lower the foot and depress the foot control. The machine will darn and stop automatically. LED display will show a blinking dot when the darning is finished. NOTE: The maximum length and width 2 cm and 0.7cm respectively. Sew another layer of darninc the right angle. _i_ Button _2_Starting pc _3_ Maximum (4_ Maximum (2cm) (5_ Blinking _revious (1) To sew a shorter g Sew the first row to the required length and press the reverse stitch button. Continue to sew the remaining stitches until the machine stops automatically. _6_Reverse stitch button _7_Required length (2) Adjusting the evenness of the darning Press the mode selection key to enter the stitch length adjusting mode. The LED display shows d5, which indicates the neutral setting. (A) If the left corner is lower than the right side, press the Up (+) key to correct it. (B) If the right corner is lower than the right side, press the Down (-) key to correct it. NOTE: Allowable adjustment range is dl-d9. O9 E:i E:2[131 AAAAAAAA I111111111111111 It11111111111111 I111111111111111 I111111111111111 I111111111111111 I111111111111111 IVVVVVVVI 0) /' // (2) 11" IIIlUlIIIII VVVVVVVl J AAAAAAAA AAAAAAAA IIIIIIIit1111111 IIIIIIIit1111111 MIIIIIIIIII MIIIIIIIIII IMtUl IMtUl IIIIIIIIIIIIIII IIIIIIIIIIIIIII IIIIIIIIIIIlUU IIIIIIIIIIIlUll IIIIIIlUlIIIIII IIIIIIlUlIIIIII IVVVVVVVI IVVVVVVVI (A) (B)