Kenwood TH-D74A User Manual 1 - Page 37
D-star
![]() |
View all Kenwood TH-D74A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
D-STAR D-STAR INTRODUCTION • In the original D-STAR (Digital Smart Technologies for Amateur Radio) plan, JARL envisioned a system of repeaters grouped together into Zones. • The D-STAR repeater enables you to call a D-STAR station in another area through the Internet. • The transceiver can be operated in the digital voice mode, including low-speed data operation, for both transmit and receive. Note: ◆ Before starting D-STAR, the following steps are needed. STEP 1: Enter your Callsign in the transceiver. STEP 2: Register your Callsign to a gateway repeater. DV MODE/ DR (D-STAR REPEATER) MODE DV (Digital Voice) mode is a mode you can use for direct call without using a repeater. DR (D-STAR Repeater) mode is a mode you can use for D-STAR repeater operation. In this mode, you can select the preprogrammed repeater or frequency in "FROM" (access repeater), and UR Callsign in "TO" (destination), as shown below. REGISTER YOUR CALLSIGN AT A GATEWAY REPEATER To use the Internet, you must register your Callsign with a repeater that has a gateway, usually one near your home location. Registration Process This section describes the Callsign registration process at a repeater that is connected to the US Trust server. There are other systems as well, and they have their own registration process. For information on how to register on one of them, contact the administrator of a repeater that uses the alternate system. If necessary, ask the gateway repeater administrator for Callsign registration instructions. 1 Access the following URL to find the gateway repeater closest to you. http://www.dstarusers.org/repeaters.php 2 Click the Callsign of the repeater that you want to register to. 3 Click the "Gateway Registration URL:" link address. TO: Destination (CQ/Other area repeater/Specific station) FROM: Access repeater DR mode (Main band) Communication in DR mode In the DR mode, the transceiver has 3 communication ways. Local area call • To call through your local area (access) repeater. Gateway call • To call through your local area (access) repeater, repeater gateway and the Internet to your destination repeater or individual station's last used repeater, using Callsign routing. Call by Callsign designation • To call by designating the Callsign of the specific station. This call is relayed automatically to the last accessed repeater. Basic operations in DR mode • Press [ ] (1s) to set "TO" (destination). You can set "TO" in Local area call, Gateway call, and Call by Callsign designation, etc. • Press [ENT] (1s) to set "TO" (destination) by Call History. You can recall in Gateway call, etc. • Press [ ] (1s) to set "FROM" (access repeater). You can select "FROM" (access repeater) in Local area call and Gateway call. Note: ◆ The basic operations in DR mode are not supported in DV mode. ◆ The transceiver has a Time-Out Timer function for digital repeater operation. The timer limits a continuous transmission to approximately 10 minutes. 4 The "D-STAR Gateway System" screen appears. Click [Register] to start the New User registration. 5 Follow the registration instructions on the registration screen. 6 When you receive a notification from the administrator, your Callsign registration has been approved, but the whole process is not yet complete. Note: ◆ It may take a few days for the administrator to approve you. 7 After your registration is approved, log in your personal account with your registered Callsign and password. 35
![](/manual_guide/products/kenwood-thd74a-user-manual-7a922ab/37.png)