Kyocera FS-1050TN User Guide - Page 76
Using Hole Punch, Position the Hole Punch, Print, Properties, Basic, Destination, Finishing, Punch
![]() |
View all Kyocera FS-1050TN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Finishing Using Hole Punch 1 In your application, open the Print dialog box, then open Properties. (Select Print from the File menu, and select Properties.) 1 2 In the Basic tab, under Destination, select a face-up or face-down finishing tray. 2 3 Click the Finishing tab, then select Punch. 3 4 Select the number of hole punches: 2 hole, 3 hole, or 4 hole. Available punch options are set in the Device Settings tab and depend on the punch unit being installed on the device and selected. For further details, refer to Installing Optional Devices on page 2-1. For information on positioning the hole punches, refer to Position the Hole Punch below. 4 • For metric specification, use 2 hole and 4 hole punch options. • For inches specification, use 2 hole and 3 hole punch options. 5 Click OK to return to the Print dialog box. 5 6 Click OK to start printing. 6 The print job will be punched by the finishing device and delivered to the output tray. For further details about hole punch specifications, refer to your finishing device's Operation Guide. Position the Hole Punch Note: Some models do not support the punch position option. 5-6 KX Driver
![](/manual_guide/products/kyocera-fs1050tn-user-guide-15dc1f0/76.png)