Kyocera KM-2030 2030 Instruction Handbook Rev 2C - Page 53
Paper type 1st to 4th, Paper type bypass, Select ejector of FAX, Special paper, will appear
View all Kyocera KM-2030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
CHAPTER 6 COPIER MANAGEMENT 3 Special paper 1 Press the cursor down or up key to select the paper feed drawer to be marked with (*). 5 Paper type (1st to 4th) 1 Press the cursor down or up key to select the paper type. 2 Press the cursor right or left key. The mark (*) will appear aside the paper feed drawer. Press the cursor right or left key again to cancel it. 2 Press the enter key. NOTE • The setting procedure for the paper type is the same for Drawers 1, 2, 3 and 4. NOTE • More than two marks can be put. 3 Press the cursor up key to select "End" and press the enter key. 6 Paper type (bypass) 1 Press the cursor down or up key to select the paper type. 4 APS 1 Press the cursor down or up key to select "On" or "Off". 2 Press the enter key. 2 Press the enter key. 7 Select ejector of FAX The optional fax board and job separator must be installed to perform this setting. If not, this setting will not be displayed. 6-17