Lenovo ThinkCentre M70z Hardware Maintenance Manual (HMM) - Page 111

Replacing the front panel control board

Get Lenovo ThinkCentre M70z PDF manuals and user guides View all Lenovo ThinkCentre M70z manuals
Add to My Manuals
Save this manual to your list of manuals

Page 111 highlights

12. Install the screw that secures the new power switch module to the front bezel. 13. Install the 21 screws to secure the main bracket to the front bezel. 14. Reconnect all the cables that were disconnected. 15. Go to "Completing the parts replacement" on page 111. Replacing the front panel control board Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support This section provides instructions on how to replace the front panel control board. To replace the front panel control board, do the following: 1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer. 2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up. 3. Remove the computer cover. See "Removing the computer cover" on page 71. 4. Locate the front panel control board in the computer. See "FRU locations" on page 67. 5. Remove the 21 screws that secure the main bracket to the front bezel. 6. Note the locations of all cable connections that prevent you from lifting the computer main bracket, and disconnect all cables. See "System board parts and connectors" on page 69. 7. Lift the main bracket off the front bezel. 8. Remove the three screws 1 that secure the front panel control board to the front bezel. Chapter 8. Replacing FRUs 105

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
12. Install the screw that secures the new power switch module to the front bezel.
13. Install the 21 screws to secure the main bracket to the front bezel.
14. Reconnect all the cables that were disconnected.
15. Go to “Completing the parts replacement” on page 111.
Replacing the front panel control board
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the
ThinkCentre Safety and Warranty Guide
that came with your computer. To obtain a copy
of the
ThinkCentre Safety and Warranty Guide
, go to:
This section provides instructions on how to replace the front panel control board.
To replace the front panel control board, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 71.
4. Locate the front panel control board in the computer. See “FRU locations” on page 67.
5. Remove the 21 screws that secure the main bracket to the front bezel.
6. Note the locations of all cable connections that prevent you from lifting the computer main bracket, and
disconnect all cables. See “System board parts and connectors” on page 69.
7. Lift the main bracket off the front bezel.
8. Remove the three screws
1
that secure the front panel control board to the front bezel.
Chapter 8
.
Replacing FRUs
105