Netgear DG834G DG834Gv5 Reference Manual - Page 112
Setting Up a Gateway-to-Gateway VPN Configuration, Connection Name
UPC - 606449029918
View all Netgear DG834G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Wireless ADSL2+ Modem Router DG834G User Manual While the connection is being established, the Connection Name field in this screen displays SA before the name of the connection. When the connection is successful, the SA changes to the yellow key symbol shown in the previous figure. Note: While your PC is connected to a remote LAN through a VPN, you might not have normal Internet access. If this is the case, you must close the VPN connection to have normal Internet access. Setting Up a Gateway-to-Gateway VPN Configuration Note: This section describes how to use the VPN Wizard to set up the VPN tunnel using the VPNC default parameters listed in Table 6-2 on page 6-4. If you have special requirements not covered by these VPNC-recommended parameters, refer to "Setting Up VPN Tunnels in Special Circumstances" on page 6-32 for information about how to set up the VPN tunnel. Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard. Figure 6-19 6-18 v1.0, May 2008 Virtual Private Networking