Netgear WNHDE111 WNHDE111 User Manual - Page 16

Prepare for Installation, To ensure proper heat dissipation and for bridge stability

Get Netgear WNHDE111 - 5 GHz Wireless-N HD Access Point/Bridge PDF manuals and user guides
UPC - 606449054279
View all Netgear WNHDE111 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

WNHDE111 5GHz Wireless-N HD Access Point/Bridge User Manual Prepare for Installation Carefully peel off the protective film covering both sides of your bridge Figure 1 Set up your bridge by inserting the tabs of the stand into the slots on its bottom as shown. Then, remove the protective film covering the status light panel. Figure 2 Place your bridge in a suitable area for installation (near an AC power outlet and accessible to the Ethernet cables for your wired connections). Note: To ensure proper heat dissipation and for bridge stability, it is important that you connect the stand, place your bridge in an upright position, and do not block the vent holes at the top. 1-2 Getting Acquainted v1.1, May 2008

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
WNHDE111 5GHz Wireless-N HD Access Point/Bridge User Manual
1-2
Getting Acquainted
v1.1, May 2008
Prepare for Installation
Carefully peel off the protective film covering both sides of your bridge
Set up your bridge by inserting the tabs of the stand into the slots on its bottom as shown. Then,
remove the protective film covering the status light panel.
Place your bridge in a suitable area for installation (near an AC power outlet and accessible to the
Ethernet cables for your wired connections).
Figure 1
Figure 2
Note:
To ensure proper heat dissipation and for bridge stability, it is important that
you connect the stand, place your bridge in an upright position, and do not
block the vent holes at the top.