Oki OKIPOS408II OKIPOS 408II Programmer s Technical Reference - Page 145

(2) Set bar code data This command sets the bar code print data. There are four types of data that can be set using QR codes. They are: numbers; English characters; binary; and Kanji. Furthermore, there are two types of data setting methods. One is to specify these along with the bar code data (data manual analysis), and the other is to specify only the bar code data (data automatic analysis). (3) Set page mode This command is not used. (4) Print Bar code This command prints bar codes based on the settings of (1) to (3). (5) Set bar code type This command confirms whether to print bar codes based on the settings of (1) to (3). = Precautions on using these commands = • The setting values for (1) to (3) are held unless any of the following operations are performed. • Sending a new setting command • Sending an initialize command ( @, ) • Turning the power OFF • When there is an error in sending a command with (2), the set data is cleared and the command itself is disabled. • (4) and (5) are sent when necessary. • Printing: • When printing, position movement using specify absolute position, specify relative position, and align position are enabled. • Upside down printing and 2-color printing are possible. • Printed bar codes should always be checked in an actual use. STAR Line Mode Command Specifications 3-127