Oki OKIPOS408II OKIPOS 408II Programmer s Technical Reference - Page 62
Cutter Control, ESC d n, tter˚Control
View all Oki OKIPOS408II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
3.3.11. Cutter Control ESC d n [Name] Auto-cutter [Code] ASCII ESC d n Hex. 1B 64 n Decimal 27 100 n [Defined Area] 0≤d≤3 48≤d≤51 ("0"≤d≤"3") [Initial Value] [Function] - - Executes the auto-cutter. After auto-cutter is executed, the printer considers that to be the top of the page. n 0, 48 1, 49 2, 50 3, 51 Auto cutter Full cut at the current position. Print data in line buffer is printed before a full cut. This command is ignored if the printer is not equipped with an auto-cutter. Partial cut at the current position. Print data in line buffer is printed before a partial cut. This command is ignored if the printer is not equipped with an auto-cutter. Paper is fed to cutting position, then a full cut. Print data in line buffer is printed before the operation described above. This command is ignored if the printer is not equipped with an auto-cutter. Paper is fed to cutting position, then a partial cut. Print data in line buffer is printed before the operation described above. This command is ignored if the printer is not equipped with an auto-cutter. (*) The auto-cutter function operates in the following ways on models that only have a full cut or a partial cut. • Models that perform only a full cut. Executes a full cut when there are instructions calling for a partial cut. • Models that perform only a partial cut. Executes a partial cut when there are for instructions calling for a full cut. (*) When connected with a presenter, executes a full cut when instructed for a partial cut. STAR Line Mode Command Specifications 3-44