Oki OKIPOS408II OKIPOS 408II Programmer s Technical Reference - Page 171
ESC GS h 1 k m n
View all Oki OKIPOS408II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
ESC GS h 1 k m n [Name] Water mark function [Code] ASCII ESC GS h 1 Hex. 1B 1D 68 31 Decimal 27 29 104 49 km n km n km N [Defined Area] [Initial Value] [Function] 0 ≤ k ≤ 2, 0 ≤ m ≤ 2, 1 ≤ n ≤ 255 --Sets the water mark function to be valid/invalid. k Water Mark Function 0 Invalid 1 Valid Prints one specified logo at a position centered horizontally and vertically. 2 Valid Repeats printing of the specified logo from the top edge to the bottom edge at positions centered horizontally. • To set to an appropriate image as the water mark using this setting, set the method for forming The logo data to be printed as the water mark. If it is not possible to set an appropriate image with this setting, form the logo data registered as the water mark into the appropriate data and reregister it. m Water Mark Data Forming 0 Prints the logo data specified by n as it is. 1 Prints the logo data specified by n thinned 25%. 2 Prints the logo data specified by n thinned 12.5%. • Specify the registered logo in the water mark. n 1 to 255 Logo Number Registered logo numbers. If the specified logo number is not registered, the water mark will not be printed. When the water mark function is valid, the water mark is printed by its trigger. However, this function is effective for print data that can be contained in the image buffer length. Print data beyond the image buffer length is unaffected by this function. Printing that is started other than the water mark trigger ignores the water mark print. When in 2-color printing, this function is ignored. Water mark printing triggers • Cutter command: d n • FF command: • BM detection command: d n, • Print start command: g 0 m n • Raster mode: When is executed. Use example 1) Register logo to use as water mark in logo number 1. 2) Water mark function is enabled: h 1 k m n (k = 0x02, m = 0x01, n = 0x01) 2) Print data transfer: Print data (Print length is less than length of image buffer.) 3) Trigger command transfer: d n (Cutter command is water mark printing trigger.) STAR Line Mode Command Specifications 3-153